CJSA Eze-Flex® 25 is a closed cell, crossed linked, non-absorbent polyethylene expansion joint fillerboard for use in expansion and isolation joints in concrete and masonry structures. Eze-Flex® 25 is non-absorbent and has excellent properties allowing it to be used in water retaining and excluding structures where potable, salt, chlorine and sewerage water is prevalent.
Note: The product’s design and performance, its intended use, installation and final confirmation and approval for use, must be provided by the project’s Design Engineer and Project Manager
Note: The above physical properties are test results from an in-house laboratory test report. Material properties can vary between batches of ± 10%. Project specific material properties can be custom produced to order.
Eze-Flex® 25 is cut to size from sheets with a sharp retractable blade and adhered to the first concrete structure by a contact adhesive. Adhesive is applied directly to the Eze-Flex® 25 in 50mm diameter ‘spots’ @ 300mm centers (approximately) or as required. Also refer to our installation method, available upon request.
Where shown in the drawings, the expansion joint fillerboard shall be Eze-Flex® 25 , closed cell/cross-linked polyethylene fillerboard material, as supplied by CJSA. The application / installation of the product must be in accordance with the manufacturer’s recommendations.
For further information or advice on health and safety precautions, safe handling, storage and correct disposal of products, please refer to the most recent product Safety Data Sheet (SDS), which is available upon request.
The information and the recommendations relating to the application and end use of this product are given in good faith and are based on the information provided by the manufacturer of the product and/or the Company’s current knowledge and experience in connection with the product when properly stored, handled and applied under normal conditions and no liability of final function at the job site is assumed. In practice, the differences in materials, substrates and actual site conditions are such that no warranty in respect of merchantability of, or fitness for, particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written and/or oral recommendations, or from any other advice offered by the Company. The Company also has no express or implied knowledge of any particular purpose for which the product is required and any such information given will not be taken into account in the supply of this product. No responsibility or liability by the Company will be accepted for misuse, misreading or derivation from recommended guidelines in respect of this product and the user shall determine the suitability of the product for his intended use and assume all risks and liability in connection therewith. The information contained in our brochure may change at any time without notice. Any use of this product, Eze-Flex® 25, in any application should be approved as suitable for use/application by the Design Engineer and Project Manager.
Be the first to hear about upcoming sales, special events, and DIY ideas.